Gerade angezeigt 1 - 2 von 2
  • Some of the metrics are blocked by your 
    Item-typ:Veröffentlichung,
    Neue Sicherungselemente und Leistungsschalter auf der Basis des Dualen Thyristors
    The Phd thesis presents a simulation study on power device structures based on a dualization of the thyristor equivalent circuit. This dualization results in new power devices, namely, "Circuit Breaker" and "Safe Controlled Power Switch". Both the circuit breaker and the safe controlled power switch can be used to protect against over currents. The circuit breaker exhibits self protection against over currents while the safe controlled power switch with inherent over current turn-off capability is controlled by the MOS gates of the device. These novel power devices have very good on-state characteristics that are comparable to the on-state characteristics of the injection enhancement IGBTs.
    Dissertation
      335  147
  • Some of the metrics are blocked by your 
    Item-typ:Veröffentlichung,
    Neue Emitterkonzepte für Hochspannungsschalter und deren Anwendung in der Leistungselektronik
    Nowadays conventional power pin-diodes have reached a mature development level in which no essential improvements can be expected. To drastically improve on state and switching properties, new design concepts are needed. Some solutions can be found in the literature. However, they show severe disadvantages from the chip fabrication and applicationpoint of view. New design concepts for silicon diodes with a blocking voltage larger than 2-3kV arepresented in this work. Using an additional gate signal terminal, the emitter efficiency of the p-emitter can be controlled, resulting in a state dependent suitable on-state and turn off bahaviour. The diode is therefore called Emitter Controlled Diode = ECD. Additional advantages are the blocking capability under all operating conditions compared to otherdesign concepts, good turn off characteristics even under critical switching conditions and apositive temperature coefficient. Investigations under severe turn off conditions have shown, that the turn on of a parasitic bipolar transistor is not critical. Comparing the emitter controlled diode with a conventional pin-diode with same power losses the current density can be increased by 30% and the silicon area can be reduced as well. Emitter controlled diodes can be fabricated with the standard power MOSFET production process. No additional masks or local lifetime control is needed.The basic concepts developed in this thesis are used to design an emitter controlled diode.The technological realisation has already been started.
    Dissertation
      292  334