Lade...
Journal Title
Catalysis Today
3 Ergebnisse
Filter
Einstellungen
Gerade angezeigt 1 - 3 von 3
- Some of the metrics are blocked by yourconsent settings
Item-typ:Veröffentlichung, Doped samarium oxide xerogels for oxidative coupling of methane - Effects of high-valence dopants at very low concentrations(Elsevier, 2021-04-01); ; Hagelin Weaver HelenaThe effects of high-valance dopants on the catalytic properties of samarium oxide xerogels were investigated at concentrations of 0.1 and 1.0 % (by mol) in the oxidative coupling of methane (OCM). Gd, Y, Zr, and V dopants were selected to examine the influence of oxidation states between +3 and +5 on the OCM performance. Even at these low loadings, the high-valance dopants were observed to have a significant impact on the OCM reaction. At the lowest loading, 0.1 mol %, and below 700 °C, all dopants improved the activity over that of the pure Sm2O3 xerogel, and most also improved the selectivity. In particular, the ethylene yield was significantly improved over these catalysts between 500 and 700 °C. However, the stability of the doped catalysts compared to the undoped Sm2O3 xerogel were inferior above 700 °C, and the higher concentration (1.0 mol %) resulted in catalysts with a lower stability. Time-on-stream experiments revealed that the 0.1 mol % high valence dopants improved the stability of the Sm2O3 xerogel at 700 °C. As a result of the higher stability, the doped catalysts retain more of the original specific surface area and appear to stabilize the more active cubic Sm2O3 phase compared with the undoped catalyst. Therefore, the doped catalysts have a higher number of available basic sites during reaction. This study reveals that high-valence dopants have potential to improve the low temperature (500–700 °C) activity of OCM catalysts. However, the concentrations must be kept very low, as dopants that increase the activity and selectivity at concentrations of 0.1 mol % can result in inferior catalysts at 1.0 mol %, and temperatures above 700 °C must be avoided or rapid deactivation can occur.Wissenschaftlicher ArtikelBand:36533 44 - Some of the metrics are blocked by yourconsent settings
Item-typ:Veröffentlichung, In situ analysis of gas phase reaction processes within monolithic catalyst supports by applying NMR imaging methods(Elsevier, 2016-06-07); ; ; ; Measuring spatially resolved concentration distributions in gas phase reaction systems is an important tool to validate simulation calculations, improve the understanding of transport processes within the catalyst, and identify potentials for improvements of monolithic catalyst supports. The commonly used measurement methods for such opaque systems are invasive and, thus, might be misleading due to alteration of the system. To overcome this issue, a 3D magnetic resonance spectroscopic imaging (MRSI) method was developed and implemented on a 7-Tesla NMR imaging system to map the concentration distributions within opaque monolithic catalysts using the ethylene hydrogenation process as case study. The reaction was catalyzed by a coated sponge packing or a honeycomb monolith within an NMR compatible packed bed reactor. Temperatures at the inlet and the outlet of the catalyst beds were simultaneously determined by analyzing the spectra of inserted ethylene glycol filled glass capsules. Steady state concentration profiles and temperature levels were measured at different reaction conditions. In order to prove the plausibility of the measured spatial distributions of compound concentrations, the experimental results were compared to a 1D model of the reactor based on kinetic data from literature. Furthermore, a comparison with integral concentration measurements using a mass spectrometer demonstrated deviations below 5%. The results show that 3D MRSI is a valuable and reliable tool to non-invasively measure spatially resolved process parameters within optically and/or mechanically inaccessible structured monolithic catalyst supports, even if only standard thermal polarization is exploited and the use of expensive and technically challenging signal enhancement techniques (hyperpolarization) is avoided. We expect that 3D MRSI can pave the way toward deeper insight into the interactions between catalyst, catalyst support, and gas phase.Wissenschaftlicher ArtikelBand:273117 133 - Some of the metrics are blocked by yourconsent settings
Item-typ:Veröffentlichung, Effects of low molar concentrations of low-valence dopants on samarium oxide xerogels in the oxidative coupling of methane(Elsevier, 2021-04-01); ; The effects of low-valence dopants on the catalytic properties of samarium oxide xerogel catalysts were investigated in the oxidative coupling of methane (OCM). More specifically, very low concentrations (0.1 and 1.0 % by mol) of transition metal (Ag, Ni, and Cu) and traditional alkali metal (Li and K) dopants were investigated. At these low loadings, it was shown that transition metal dopants have potential to improve the activity and selectivity over an undoped Sm2O3 xerogel, but these dopants can only outperform alkali metal dopants under certain conditions. Even at a concentration of 0.1 mol %, the dopants significantly increased the number of basic sites compared with the pure Sm2O3 xerogel. However, no trend is evident between the number or strength of the basic sites and the activity or selectivity in the methane coupling reaction. The XRD data reveal a lattice expansion upon addition of the low valence dopants, which is consistent with substitutional doping and the formation of oxygen vacancies due to charge compensation. In most cases the majority of the dopant stayed in the lattice during reaction. The dopants were also shown to influence the Sm2O3 structure, and the dopants that were more effective in suppressing the transformation from cubic to monoclinic Sm2O3 in general resulted in the more active and selective catalysts. While the Ag- and Ni-dopants could outperform the alkali metal doped catalysts in narrow temperature ranges, the best performing catalysts were still the K-doped Sm2O3 catalysts, as the 1.0 % K catalyst exhibited the highest activity at the lowest temperature (500 °C) and the 0.1 % K-doped catalyst was the most stable during extended operation. These results indicate that transition metal dopants, at low concentrations, can positively affect the activity and selectivity of a methane coupling catalyst, such as Sm2O3, and suggests that there may be benefits to other OCM catalyst systems from traditionally non-selective dopants, as long as the concentrations are kept very low and stability issues are addressed.Wissenschaftlicher ArtikelHeft:36532 42