Graupner, NinaMüssig, Jörg2022-07-292022-07-292022-05-112296-8016https://media.suub.uni-bremen.de/handle/elib/6093In this study, the apparent interfacial and interlaminar shear strength (IFSS and ILSS) of single fibres and unidirectional (UD) viscose fibre-reinforced epoxy composites were characterised using different test methods. Microbond and pull-out tests were used to analyse the IFSS of single fibres embedded in epoxy and the transverse tensile test was applied to measure the IFSS of UD fibre-reinforced composites. The short beam shear test, single edge notched bending test (SENB), double-notched tensile test and double-notched compression test were applied to characterise the ILSS. The composites were produced from continuous tows with fibre mass fractions of 20%, 30% and 40% and fibres of different fineness (1.7, 3.3 and 28.0 dtex). The results showed that the different test procedures led to different trends of ILSS depending on the fibre mass fraction and fibre fineness used. The transverse tensile test revealed that the IFSS decreased with increasing fibre mass fraction and fibre diameter. A different trend was found with the short beam shear test and the SENB test for the ILSS. Here, higher values were detected with increasing fibre mass content, and the influence of the fineness was less noticeable. The double-notched shear tests (tensile and compression) showed a different trend: the ILSS increased with increasing fibre mass fraction from 20% to 30%. With a further increase to 40%, the ILSS tend to decrease slightly. An influence of the fibre fineness on the ILSS could not be statistically proven. The different trends of the test methods are attributed to the constitution of the composite and the different load application caused by the test procedures.enCC BY 4.0 (Attribution)https://creativecommons.org/licenses/by/4.0/interfacial shear strengthinterlaminar shear strengthshort beam shear testSENB-testdouble-notched shear testtransverse tensile testmicrobond testpull-out test80Artikel/Aufsatz