Now showing 1 - 4 of 4
  • Some of the metrics are blocked by your 
    Item type:Publication,
    Model-based review of Doppler global velocimetry techniques with laser frequency modulation
    (Elsevier Science, 2017-06)
    Optical measurements of flow velocity fields are of crucial importance to understand the behavior of complex flow. One flow field measurement technique is Doppler global velocimetry (DGV). A large variety of different DGV approaches exist, e.g., applying different kinds of laser frequency modulation. In order to investigate the measurement capabilities especially of the newer DGV approaches with laser frequency modulation, a model-based review of all DGV measurement principles is performed. The DGV principles can be categorized by the respective number of required time steps. The systematic review of all DGV principle reveals drawbacks and benefits of the different measurement approaches with respect to the temporal resolution, the spatial resolution and the measurement range. Furthermore, the Cramér-Rao bound for photon shot is calculated and discussed, which represents a fundamental limit of the achievable measurement uncertainty. As a result, all DGV techniques provide similar minimal uncertainty limits. With Nphotons as the number of scattered photons, the minimal standard deviation of the flow velocity reads about 106 m/s/ √Nphotons , which was calculated for a perpendicular arrangement of the illumination and observation direction and a laser wavelength of 895 nm. As a further result, the signal processing efficiencies are determined with a Monte-Carlo simulation. Except for the newest correlation-based DGV method, the signal processing algorithms are already optimal or near the optimum. Finally, the different DGV approaches are compared regarding errors due to temporal variations of the scattered light intensity and the flow velocity. The influence of a linear variation of the scattered light intensity can be reduced by maximizing the number of time steps, because this means to acquire more information for the correction of this systematic effect. However, more time steps can result in a flow velocity measurement with a lower temporal resolution, when operating at the maximal frame rate of the camera. DGV without laser frequency modulation then provides the highest temporal resolutions and is not sensitive with respect to temporal variations but with respect to spatial variations of the scattered light intensity. In contrast to this, all DGV variants suffer from velocity variations during the measurement. In summary, the experimental conditions and the measurement task finally decide about the ideal choice from the reviewed DGV methods.
    journal article
    Band:
      86  153
  • Some of the metrics are blocked by your 
    Item type:Publication,
    Lens-based phase retrieval under spatially partially coherent illumination - Part I: Theory
    We present a novel approach of phase retrieval using a 4f-imaging system, for the specific case of spatially partially coherent illumination. The theoretical investigation presented in Part I is based on scalar diffraction theory in combination with a heuristic approach. We find that the intensity of the de-focused speckle fields across the image plane shows sufficient contrast for phase retrieval, as long as the radius of the point spread function of the imaging system is well below the radius of the correlation area (spatial coherence) in the object plane. We also derive a useful relation, which allows to determine the requirements towards the essential parameters of an experimental setup, such as maximum propagation distance, diameter of the source, illumination distance and the numerical aperture of the imaging system. The consecutive paper, Part II, describes shape measurement based on the present treatise.
    journal article
    Band:
      26  68
  • Some of the metrics are blocked by your 
    Item type:Publication,
    Lens-based phase retrieval under spatially partially coherent illumination - Part II: Shape measurements
    We experimentally demonstrate the shape measurement of micro objects by means of phase retrieval under spatially partially coherent illumination. This approach offers an extended depth of focus, vibration insensitivity, short measurement time and precise shape measurements, enables the use of spatially extended light sources such as LEDs and thus significantly improves the eye safety of the method. The employed setup is based on a telecentric -imaging system with a tunable lens across the common Fourier plane. Based on the theoretical investigation presented in Part I, we verify that -based phase retrieval is feasible if the radius of the point spread function of the imaging system is smaller than that of the correlation (spatial coherence) area across the object plane. In this case, a light field with a defined complex amplitude can be assigned to the measured intensity distributions. As a proof of principle towards industrial applications, the 3D shape of a cold-formed micro-cup is reconstructed by combining phase retrieval with two-wavelength contouring. A depth of focus in the range of few millimeters and the measurement time and uncertainty of 0.4 s, and m, respectively, can be achieved.
    journal article
    Band:
      37  35
  • Some of the metrics are blocked by your 
    Item type:Publication,
    Influence of inhomogeneous refractive index fields on particle image velocimetry
    (Elsevier Science, 2018-08) ;
    The influence of inhomogeneous refractive index fields on particle image velocimetry (PIV) measurements is a well known problem, which leads to an unknown measurement uncertainty in, e.g., flame flows, shock waves and super sonic flows. Previous studies give only rough estimations of the measurement error due to inhomogeneous refractive index fields, and quantitative information is only available for special conditions such as a gradient of the refractive index independent of the viewing direction. Hence, the assessment of the spatial distribution of the quantitative measurement errors inside inhomogeneous refractive index distributions especially for stereoscopic and tomographic PIV is an open question. For this purpose, the flow measurement inside a hot jet flow is considered as an example, and a general analytic description of the error of the measured particle positions inside the hot jet flow is derived, numerically evaluated and finally validated by experiments. In particular, the determination of the particle position with triangulation is investigated, which is performed in stereoscopic and tomographic PIV. As a result, the measurement error is generally larger than for standard PIV without triangulation. The theoretically predicted errors of the measured particle position are validated with experiments and here amount to 11.7 µm for standard PIV and 17.3 µm for triangulation at the same distance from the center of the flow, respectively. Note that the error estimation requires the knowledge of the refractive index field that was determined by temperature measurements in the flow. Furthermore, the error analysis shows that for triangulation the measured particle position depends on the gradient and the curvature of the refractive index field, whereas for standard PIV the measured particle position only depends on the gradient of the refractive index. For the given temperature profile with a maximum temperature of 191 °C, the resulting flow velocity error is maximally 0.8 % with standard PIV, 1.7 % for the in plane and 2.9 % for the out of plane direction with stereoscopic PIV and 1.1 % with triangulation which is performed in tomographic PIV.
    journal article
    Band:
      74  118